User guide

PROSTAR DCS COMPACT PROGRAMMING
TECHNICAL MANUAL PART 2 APRIL 1995
MMC: 105 STATION SPEED DIAL
DESCRIPTION:
Allows the system administrator or technician to program the personal speed dial
locations assigned to a station. This must be done for single line telephones
because these stations cannot access programming. Each station may have up to
50 locations or bins assigned to it in MMC 606 Assign Speed Block. The speed dial
bins are numbered 00–49. Each speed dial number consists of a trunk or trunk
group access code followed by a separator and up to 18 digits to be dialed. These
dialed digits may consist of 0–9, 4 and #. If the system recognizes a valid trunk or
trunk group access number, it will automatically insert the separator.
PROGRAM KEYS
UP & DOWN Used to scroll through options
KEYPAD Used to enter selections
SOFT KEYS Move cursor left and right
SPK Used to store data and advance to next MMC
HOLD Used to clear previous entry
B Used to insert a flash code “F”
C Used to insert a pause code “P”
D Used to insert a pulse/tone conversion code “C”
E Used to mask/unmask following digits (shows as “[” or “]”)
F Used to enter name for speed dial bin (see MMC 106)
ACTION DISPLAY
1. Press TRSF 105
Display shows
[201] SPEED DIAL
00 :
2a. Dial station number (e.g. 205)
OR
[205] SPEED DIAL
00 :
Press UP or DOWN to select station
and press RIGHT soft key to move cursor
OR
Press LEFT soft key to go to step 4
2b. If selected station has no speed dial
bins, the display will be as shown and
[205] SPEED DIAL
SPDBLK NOT EXIST
a new station may be selected
HOME
PAGE
Table of
Contents