User guide

PROSTAR DCS COMPACT PROGRAMMING
TECHNICAL MANUAL PART 2 DECEMBER 1994
MMC: 800 ENABLE TECHNICIAN PROGRAM
DESCRIPTION:
Used to open and close technician level programming. If programming is not
opened and an attempt is made to access a system MMC, the error message
“ACCESS DENIED” will be displayed.
A four digit passcode is required to access this MMC. Each character can be digits
0–9 or . When opened, this MMC enables access to all MMCs.
PROGRAM KEYS
UP & DOWN Used to scroll through options
KEYPAD Used to enter selections
SOFT KEYS Move cursor left and right
SPK Used to store data and advance to next MMC
ACTION DISPLAY
1. Press TRSF 800
Display shows
ENABLE TECH.PROG
PASSCODE:
2. Enter passcode
ENABLE TECH.PROG
PASSCODE:4321
Correct code shows
ENABLE TECH.PROG
DISABLE TENANT:1
Incorrect code shows
ENABLE TECH. PROG
PASSCODE ERROR
3. Press UP or DOWN to open or close
OR
ENABLE TECH.PROG
ENABLE TENANT:1
Enter 1 to enable or enter 0 to disable
Press RIGHT soft key to move to tenant
number and enter tenant number (1–2)
ENABLE TECH.PROG
ENABLE TENANT:1
4. Press SPK to advance to MMC entry level
801:TEC.PASSCODE
SELECT PROG.ID
HOME
PAGE
Table of
Contents