User guide

PROSTAR DCS COMPACT PROGRAMMING
TECHNICAL MANUAL PART 2 FEBRUARY 1996
MMC: 705 PROGRAM SYSTEM SPEED DIAL
DESCRIPTION:
Enables the assignment of system speed dialing numbers. There are up to 500
entries available for programming.
Each speed dial number consists of a trunk or trunk group access code followed by
a separator and up to 18 digits to be dialed. These dialed digits may consist of 0–9,
 and #. If the system recognizes a valid trunk or trunk group access number, it will
automatically insert the separator.
PROGRAM KEYS
UP & DOWN Used to scroll through options
KEYPAD Used to enter selections
SOFT KEYS Move cursor left and right
SPK Used to store data and advance to next MMC
HOLD Used to clear previous entry
B Used to insert a flash code “F”
C Used to insert a pause code “P”
D Used to insert a pulse/tone conversion code “C”
E Used to mask/unmask following digits. shows as “[“ or “]”
F Used to enter name for speed dial bin (see MMC 706)
ACTION DISPLAY
1. Press TRSF 705
Display shows
SYS SPEED DIAL
500:
2. Dial desired speed index (e.g., 505)
OR
SYS SPEED DIAL
505:
Press UP or DOWN key to make selection
and press RIGHT soft key to move cursor
3. Enter access code (e.g., 9/701) plus the
phone number up to 18 digits (digits will
SYS SPEED DIAL
505:9–1212234567
scroll under) and press RIGHT soft key to
return to step 2
4. Press F key to toggle to MMC 706, step 3 to
enter name
SYS SPEED NAME
505:
HOME
PAGE
Table of
Contents