User guide

PROSTAR DCS COMPACT PROGRAMMING
TECHNICAL MANUAL PART 2 DECEMBER 1994
MMC: 603 ASSIGN TRUNK GROUP
DESCRIPTION:
Allows the assignment of trunks to a specific trunk group or to several trunk groups.
This is very useful in the programming of LCR when more than one trunk is to be in
several dialing plans. There are two different modes of operation: (1) sequential and
(2) distribute.
WARNING: As stated above, one trunk can appear in more than one trunk
group. If necessary, delete the trunk member from other groups to prevent
accidental access.
PROGRAM KEYS
UP & DOWN Used to scroll through options
KEYPAD Used to enter selections
SOFT KEYS Move cursor left and right
SPK Used to store data and advance to next MMC
HOLD Used to clear previous entry
ANS/RLS Used to select ALL
ACTION DISPLAY
1. Press TRSF 603
Display shows
[9] TRK GROUP
MODE:SEQUENTIAL
2. Enter valid trunk group (e.g., 9, 80–89)
OR
[81] TRK GROUP
MODE:SEQUENTIAL
Press UP or DOWN key to make selection
and press RIGHT soft key to advance cursor
3. Press RIGHT soft key to change mode
OR
[81] TRK GROUP
MEMBER 01:NONE
Press UP or DOWN key to change mode to
member
HOME
PAGE
Table of
Contents