Installation Guide

LEAK TESTING

Remove the 2 screws securing

the valve panel to the unit using

a Phillips screwdriver.

Remove all dials by pulling outwards.

Pull the valve panel down then

outward and unplug any wires.

Removing the valve panel

Testing for leaks

Prepare soap solution by combining

one part liquid detergent and one

part water. Pour into a spray bottle.

Ensure all control valves are in the

OFF position before turning the gas

supply ON.

Check all connections from the

supply line or LP cylinder by

applying the solution around the

connection, tubing and end of the

manifold. Soap bubbles will appear

where a leak is present.

A complete gas tightness check must be performed at the installation site. Periodically check

the whole system for leaks, or immediately if the smell of gas is present.

If a leak is present

Immediately turn the gas supply

OFF and tighten any leaking connections. Turn gas ON,

and recheck. If you cannot stop a gas leak turn the gas supply OFF and call your local gas

utility or the dealer you purchased the appliance from. Only parts recommended by the

manufacturer should be used on the side burner/griddle, substitution can void the warranty.

leak points

NG:

leak points

LP: