User Guide

dCS Verdi User Manual Manual for Software Issue 1.2x
dCS Ltd September 2004
Manual filename: Verdi Manual v1.2x.doc Page 28 email: [e-mail]
English version web-site: www.dcsltd.co.uk
The unit is ready for use.
OOPS! If the CD transport stops or becomes disconnected during an update, don’t
worry! The original software is backed up inside the unit. Proceed as
follows:
The checking routine will find a sequencing error and Non Seq or Bad CD! will
appear on the display.
do this: Turn the power off and on to reboot. This message will scroll across the display:
Bad CheckSum – Press Function button to attempt recovery
or Bad CheckSum – Press Mute button to attempt recovery
or Bad CheckSum – Press Menu button to attempt recovery,
depending on the model.
do this: Press the appropriate button once.
The original software is retrieved from the internal backup while displaying
Wait... . This may take a few minutes. When recovery is complete, the unit
re-boots.
do this: Run the CD Update routine again to load the new software.
Factory
FactoryFactory
Factory – Restoring Factory Defaults
This feature sets most of the parameters back to the factory default settings.
This can be useful if the settings are accidentally changed and you need to
reset the unit to a standard configuration, or your children play with it.
do this: Open the Menu and step through until the display shows Factory.
do this: Press the
Select button and leave the menu to time out.
After re-booting, the unit will return to normal operation set up as follows:
• Transmit to Active
• Brightness to Bright 4
• 1394ID to 0
• Timeout to Normal
• FavLayer to SACD
• SessTime to 0