User Guide
dCS Verdi La Scala User Manual Manual for Software Issue 1.0x
dCS Ltd September 2004
Manual filename: Verdi LS Manual v1.0x.doc Page 33 email: more@dcsltd.co.uk
English version web-site: www.dcsltd.co.uk
SUC
The Software Upgrade Connector is intended to be used by dCS service agents
to load new software into La Scala.
IMPORTANT! Do not connect any other equipment to the SUC connector as this may
damage both La Scala and the equipment so connected. Do not operate La
Scala with a PC connected. Failure to observe this warning will void the
unit’s warranty, and may cause unpleasant effects in your system.
Power switch
The Power switch completely isolates the unit from the power supply. In normal
use, set it to the On position (I). Set it to Off (0) during electrical storms, or while
you are away for a long period.
IEC Power Inlet
Use with a 3 - pin IEC type power cable.
Mains Fuse
Replace only with a 20 x 5mm 500mA T HRC fuse. Please see page 52 for
replacement details.
Additional Information
The rear panel displays the following information about the unit:
• The manufacturer’s name and address.
• Supply voltage setting, frequency range and rated power.
• Model: dCS La Scala
• The short form of the unit serial number.
We will need the serial number (preferably the full serial number from the menu)
to give you support over the phone, or to ship you software updates.