User Guide

dCS Verdi La Scala User Manual Manual for Software Issue 1.0x
dCS Ltd September 2004
Manual filename: Verdi LS Manual v1.0x.doc Page 15 email: more@dcsltd.co.uk
English version web-site: www.dcsltd.co.uk
Step 4 – Setting a Repeat Sequence
If you wish, La Scala can repeat the whole disc, one track or part of a track.
Otherwise, proceed to “Other settings”.
Repeating the Whole Disc x
do this: While playing a disc in Continuous mode (CONT indicator lit), press the Repeat
button on the Remote Control to repeat the whole disc.
The display will show Rept All and the REPT indicator will light.
Repeating a Track x
do this: While playing a track disc in Continuous mode (CONT indicator lit), press the
Repeat button on the Remote Control twice to repeat the track.
The display will show Rept Trk and the REP1 indicator will light.
Repeating Part of a Track x
do this: To select part of a track to repeat, play the track through until you reach the
start point. Press the A-B button on the Remote Control, the display will show
(for example) AB 0:20 with the B flashing. When you reach the end point (for
example, 10 seconds later), press the A-B button again. The B will stop
flashing, the unit will skip back to the start point (A) then continuously repeat the
section up to stop point (B). You can select new start and stop points by
pressing the A-B button at the new start point and again at the new stop point.
Cancelling Repeat Mode x
do this: To stop repeating, press the Repeat button on the Remote Control once or
twice until the display shows Rept Off.
Other Settings
More features are available through the Menu. See the Menu section starting on
page 18 for more information.