User Guide

dCS Verdi Encore User Manual Manual for Software Issue 1.0x
dCS Ltd August 2005
Manual filename: Verdi Encore Manual v1.0x.doc Page 43 email: [e-mail]
English version web-site: www.dcsltd.co.uk
Removing the Transit Screws
The transit screws clamp the mechanism to reduce the risk of shipping damage.
They must be removed before the unit is used.
do this: Lift the unit out of the packaging and place it on a table top. Remove the rubber
mat from the top of the unit. Identify the four transit screws from the drawing
below.
Figure 7 – View of the top of the unit showing the transit screws
do this: Using the 3mm hex key, unscrew the transit screws and put them in a safe
place.
IMPORTANT! If you intend to transport the unit outside the room, replace the transit screws
– they need to be secure BUT NOT OVER-TIGHT.
Fitting the Top Glass Plate
do this: Lay the black rubber mat flat in the top of the unit so that the 4 screw holes are
visible through the holes in the mat.
do this: Remove the glass plate from its plastic bag.
do this: Find the dCS logo on the top face of the glass. Fit the glass with the logo in the
front left corner of the unit as shown in Figure 8.
do this: Carefully locate the right hand edge of the glass in the well in the top of the unit
(step 1 in Figure 8).
do this: Lower the glass down on the left hand side until it can be safely dropped into
place (step 2 in Figure 8). Centralise the glass plate.