User Guide

dCS Verdi Encore User Manual Manual for Software Issue 1.0x
dCS Ltd August 2005
Manual filename: Verdi Encore Manual v1.0x.doc Page 16 email: [e-mail]
English version web-site: www.dcsltd.co.uk
THE SOFTWARE – THE MENU
Brightness Layer Issue 1394 Issue
Serial Number
Press to open the
Menu and Select or
change options.
Sets the display
brightness
Selects format for
playing hybrid discs
Displays the
software version
number
Displays the 1394
code version
number
Displays the unit full
serial number
0 …. 15 SACD 1.00 2.06
only in this release
Exit CDUpdate
Contact Details
Closes the Menu
Starts software
update from a dCS
CD
Displays dCS email
address
Menu / Select
Figure 3 – Menu flow chart
Using the Menu
The Menu gives the user access to a wide range of additional features. It also
allows new features and performance enhancements to be added at a later date
by software upgrades.
Opening the Menu
The Menu is controlled by three buttons:
• the Menu button opens the menu and doubles as the
Select button.
• the Step →
→→
→ button pages forward through the Menu – the
Step button.
• the ←
←←
← Step button pages backward through the Menu – the
Step Back
button.
Successive presses of the
Step button page through the Menu. You cannot go
directly to any particular page, but must enter at the top of the Menu and then
page through until you reach the page you want.
Types of Menu Page
There are two types of page in the Menu - Parameter Pages and Information
Pages.
Parameter pages allow the user to check and also change the current settings
of the operating parameters, for example Brightness: 10. When a parameter
page is displayed, press the
Select button change the page setting.
Information pages display information about the unit, for example Software
Issue: 1.00..
Closing the Menu
There are two ways to close the menu and return to normal operation. The
easiest way is to wait 5 seconds for the unit to time-out and revert to the
standard display. Alternatively, use the
Step button to page forward until the
display shows Exit and then press the
Select button once.
If the unit times out before the operation in hand has been completed, simply re-
enter the menu, page forward (or backward) and continue where you left off.