User Guide

dCS Elgar Plus User Manual Manual for Software Issue 4.3x
dCS Ltd September 2004
Manual filename: Elgar Manual v4.3x.doc Page 32 email: [e-mail]
English version web-site: www.dcsltd.co.uk
Factory
FactoryFactory
Factory – Restoring Factory Defaults
This feature sets most of the parameters back to the factory default settings.
This can be useful if the settings are accidentally changed and you need to
reset the unit to a standard configuration, or your children play with it.
do this: Open the Menu and step back until the display shows Factory.
do this: Press
Select and leave the menu to time out.
After a few seconds, the unit will re-boot and return to normal operation set up
as follows:
• Input to AES1. The Input selection is automatic if the unit is connected by
a 1394 cable to another dCS unit with current software.
• Filters to Filter1
• Phase to Normal
• Swap to Off
• Master/Slave to MS:Slav on all inputs
• Brightness to Bright 4
• Display to Fs+
• Mute to Off, Normal speed
• Dual AES to Auto if an Upsampler is detected, otherwise Off
• Fade to On
• De-Emphasis to Auto
• Balance to centre
• Balance display to Bal:Num
• Volume to –30, Global
• Timeout to Normal
• PLL mode to Fine
• Non-Audio to Mute
• Delius only: Output level to Out :2V
• Other settings as you last used them.
Rst Sync
Rst SyncRst Sync
Rst Sync – Setting all Inputs to Slave Mode
This feature resets the 1394 input to Sync mode and all other inputs to slave
mode. This can be useful if you have problems setting master mode, or your
children play with it.
do this: Open the Menu and step through until the display shows Rst Sync.
do this: Press
Select and leave the menu to time out.
The display will show Reset. After a few seconds, the unit will re-boot and
return to normal operation set up as follows:
• Master/Slave to MS:Sync on 1394 input
• Master/Slave to MS:Slav on all inputs except 1394
• Other settings as you last used them.