User Guide

ManualsBrandsDCS (AUDIO) ManualsOtherELGAR AT GUIDE

dCS Elgar AT Control Summary

Standby Phase De Emph Input Mute Vol / Bal

Coax1 (RCA)

Off Coax2 (BNC)

Auto AES 1

Display

50/15us AES 2

Rotary

CCITT Opt1 (ST)

Opt2 (Toslink)

To open the Menu, hold down "Vol / Bal" and press "Display".

To page through the Menu, press "Display".

To select, display or change an option, press "Vol / Bal".

Menu Filter x Master/Slave Mute: Fade Dual AES

First page of the

Selects an optional

filter if available

Changes the

behaviour of the

selected input

Sets the Mute fade-

out rate

Audio fades up

during unmuting

after relock

Enables Dual AES

operation

Filter 1 MS:Mast Mute:Nor Fade:On Off

Filter 2 MS:Slav Mute:Fst Fade:Off On

.... MS:Sync Mute:Slw Auto

Filter n Lock

PLL TimeOut Global Bal mode Disp Swap

Sets the PLL

tracking bandwidth

Sets the Function

Menu time-out

delay

Stores global or

input-related

settings

Sets the balance

display mode

Sets the default

display

Reverse the Left

and Right outputs

PLL:Fine Normal Vol:Glob Bal:Bar Disp:Vol Swap:Off

PLL:Wide Long Vol:Inp Bal:Num Disp:Fs Swap:On

Bal:dBs Disp:Fs+

Disp:Inp

NAud Ch.Check Ph.Check Burn In Test Issue

Controls muting

when receiving non-

audio data (e.g. CD-

ROM)

Outputs tone on L

channel only then R

channel only

Outputs noise on

both channels then

inverts R

Outputs modulated

pink noise to burn-

in your system

Runs a display test

routine

Displays the

software version

number

CAUTION! LOUD!

NAud:Mut 2.5x

NAud:Ign

Use with care!

Rst Sync Factory CDUpdate Contact Serial Temp

Resets all inputs to

Slave mode

Restores standard

factory settings

Starts software

update from a dCS

Displays dCS email

address

Displays the unit

full serial number

Displays the

internal

temperature

ELG-?-?-?-?-? Celsius

Fahrenheit

End

Closes the

Function Menu

dCS Ltd.

Elgar AT Guide v2.5x English Software version 2.5x December 2004

Power On / Off or

Standby

Changes the output

phase for both

channels

Sets the display

brightness and

doubles as Menu

Step

Sets the

DeEmphasis curve

(32 - 48kS/s)

Mute / unmute all

analogue outputs

Selects Volume or

Balance adjustment

and doubles as

Menu Select

Adjusts Volume &

Balance or scrolls

along the Function

Selects the active

input

Summary of content (1 pages)

PAGE 1
dCS Elgar AT Control Summary Standby Phase De Emph Input Power On / Off or Standby Changes the output phase for both channels Sets the DeEmphasis curve (32 - 48kS/s) Selects the active input Off Auto Display Sets the display brightness and doubles as Menu Step Mute Mute / unmute all analogue outputs Coax1 (RCA) Coax2 (BNC) AES 1 50/15us AES 2 CCITT Opt1 (ST) Opt2 (Toslink) Vol / Bal Selects Volume or Balance adjustment and doubles as Menu Select Rotary Adjusts Volume & Balance or scrolls al