User Guide

dCS Delius User Manual Manual for Software Issue 2.3x
dCS Ltd September 2004
Manual filename: Delius Manual v2.3x.doc Page 37 email: [e-mail]
English version web-site: www.dcsltd.co.uk
The choices for a standard Delius are AES1 (XLR), AES2 (XLR), Dual AES
(AES 1 + AES 2 simultaneously on 2 x XLR), RCA1, RCA2, Toslink or BNC.
Dual AES is available only if both AES1 and AES2 inputs are connected to a
Dual AES source.
An IEEE 1394 interface is available as an option. Use the Input button to select
one of the sources connected to the 1394 interface.
The Input button doubles as the Menu
Step Back button, used for paging
backwards through the Function Menu (see page 21).
Mute Button (
Step)
do this: If the unit is locked to a digital source, press the Mute button to mute or unmute
the Analogue Outputs. The Mute indicator will light when the outputs are muted.
If the unit is not locked to a digital source, the Analogue Outputs are
automatically muted, the Mute indicator is lit and the Mute button has no effect.
do this: See NAud on page 29 if you need to over-ride an incorrectly set Non-Audio flag
on a disk or tape.
The Mute button doubles as the
Step button, used for paging forwards through
the Function Menu (see page 21).
Status Indicator x
This consists of 4 indicators:
• PWR is lit when power is connected and the unit is turned on.
• STBY is lit when the unit has been placed in Standby mode. The PWR
indicator will also be lit but all other indicators and controls will be inactive.
The Analogue Outputs will be muted and the unit will be operating in a
reduced power, “keep warm” condition. To return to normal operation, press
the Power button. If power is turned off or fails, Standby mode is cancelled.
• MUTE is lit whenever the Analogue Outputs are muted. This occurs if you
have pressed the Mute button during normal operation or if the unit is not
locked to a digital source (displaying No Input). If a non-audio source such
as a CD-ROM is being played, Delius will normally mute automatically to
protect your ears, power amplifier and loudspeakers.
• PHSE is lit if the phase of the Analogue Outputs has been inverted by
changing the Phse setting in the Menu, see page 27.
Remote Control Sensor x
Point the end of the Remote Control unit towards the sensor for best control
range.