User Guide

dCS Delius User Manual Manual for Software Issue 2.3x
dCS Ltd September 2004
Manual filename: Delius Manual v2.3x.doc Page 36 email: [e-mail]
English version web-site: www.dcsltd.co.uk
THE HARDWARE – CONTROLS AND CONNECTORS
Front Panel
FunctionPower Input
STBY
MUTE
PWR
PHSE
AES2
RCA2
ST
1394
AES1
RCA1
TOS
BNC
High Resolution Digital to Analogue Converter
dCS Delius
Function
step
Mute
Select
A
B C D F G H IE
Figure 7 – dCS Delius Front Panel
Key to Front Panel
A Power / Standby button
B Input selector or
Step Back button
C Mute or
Step button
D Status indicator
E Remote Control sensor
F Main Display
G Input indicator
H Function or
Select button
I Rotary control
Power Button x
This button doubles as a power on / off switch and a standby mode switch.
do this: To switch on, press the Power button briefly. If power is available, the PWR
indicator will light and Delius will run through the power up routine.
Note that the Power button will not click when turning power on – this is normal.
do this: When you have finished listening, press the Power button briefly to set the unit
to standby mode.
The Analogue Outputs will mute, all displays will turn off except the PWR and
STBY indicators. In this mode, Delius uses less power but stays warm.
do this: To restore normal operation, press the Power button briefly again.
The STBY indicator will turn off and Delius will power up ready for use.
do this: To switch off completely, press the Power button and hold it for a few seconds
until the Main Display shows Power Dn, then release it.
Input Button (
Step Back)
The Input button controls which digital input is selected, as shown by the Input
Indicator.
do this: Press the Input button repeatedly until the required input is shown on the Input
indicator.