User Guide

dCS Delius User Manual Manual for Software Issue 2.3x
dCS Ltd September 2004
Manual filename: Delius Manual v2.3x.doc Page 26 email: [e-mail]
English version web-site: www.dcsltd.co.uk
Swap
SwapSwap
Swap - Swap Channels
If you have run the Channel Check test and decided the channels are reversed,
you can swap the channels back digitally as follows.
do this: Assuming the unit is set for swap off, open the Function Menu and step through
until the display shows Swap:Off.
do this: Press the
Select button once.
The display will change to Swap:On.
do this: Run through this sequence again if you want to swap back.
The Swap setting is NOT remembered when you switch off. If your channels are
swapped, check the wiring between units and correct the error.
Disp
DispDisp
Disp - Default Display
This feature allows you to choose what Delius displays when music is playing
do this: Open the Function Menu and step through until you come to the Disp page.
Press the
Select button repeatedly and the display will cycle through the
following :
Disp:Vol The display reverts to Volume after time-out (e.g.
Vol -12.0).
Disp:Fs The display reverts to Sample Rate after time-out (e.g.
44.1kS/s).
Disp:Fs+ The display reverts to Input Bits + Sample Rate (format)
after time-out (e.g. 24/192). If receiving digital silence, 0
input bits will be correctly displayed.
Disp:Inp The display reverts to the selected input after time-out
(e.g. AES1).
do this: Choose whichever you prefer and wait for time-out.
Out
OutOut
Out - Output Level
The Analogue Output levels should be set to suit your system – there are two
levels: 6V (high) or 2V (low). The difference between the two settings is 9.5dB.
For best results, Delius’ volume control should be set to no lower than –20.0 for
normal listening levels with typical music. We suggest you start with 2V and
increase the level to 6V if this is inadequate.
Before changing the output level, please ensure you are not playing music at a
high level – the extra 9.5dB is noticeably louder. To change the setting (starting
from 2V):
do this: Open the Function Menu and step through until the display shows Out: 2V.
do this: Press the
Select button once. The display will change to Out: 6V.
do this: Run through this sequence again if you want to change back to 2V.