User Guide

dCS Delius User Manual Manual for Software Issue 2.3x
dCS Ltd September 2004
Manual filename: Delius Manual v2.3x.doc Page 12 email: [e-mail]
English version web-site: www.dcsltd.co.uk
Step 2 – Connecting the Analogue Outputs
Choose one of the following two sections:
Using a preamplifier x
do this: Set the preamplifier volume control to minimum.
do this: Connect either the balanced (XLR connectors) or unbalanced (RCA phono
connectors) outputs on Delius rear panel to matching line level inputs on your
preamplifier (probably labelled CD or AUX).
do this: Turn Delius rotary control clockwise to set the Volume to maximum (Vol 0.0 on
the display).
do this: Slowly increase the preamplifier volume until the music is at the right level.
Using a power amplifier directly x
do this: Turn Delius rotary control counter-clockwise to set the Volume to minimum
(Vol -60.0 on the display).
do this: Connect either the balanced (XLR connectors) or unbalanced (RCA phono
connectors) outputs on Delius rear panel to matching inputs on your power
amplifier. Switch on the power amplifier.
do this: Turn Delius rotary control slowly clockwise until the music is at the right level.
A basic setup with a CD player is shown in Figure 1.
do this: Proceed to Step 3.
WORDCLOCK
L
R
Hand Crafted by
The Red Hot CD Player Co.
L R
Balanced
Outputs
To Power Amplifier or Preamplifier
Unbalanced
Outputs
- or -
DIGITAL OUT
ANALOGUE OUTPUTS DIGITAL INPUTS POWER
IN - WORDCLOCK - OUT
BNC
RCA1
TOSLINK
AES1 AES2
PUS H
L R
L
R RCA2
ST
PUSH
DIGITAL OUT
REC
1
SUC
1394
R L
16 bit
44.1kS/s
Figure 1 – Basic setup with a CD player