Installation Sheet

3
Using screws provided (10-24 X 1-1/8), attach riser 7.
to the side panels. Take note of the alignment of the
holes on the riser and side panel (Fig. 11).
Adjust the side panels to be level with the top of the 8.
Icemaker, then tighten all ange screws.
The 4 male catch clips are preinstalled in the back 9.
panel. See your Icemaker Use & Care Manual for
instructions on connecting to your potable water
supply and drain. Route the supply hose thru the
large opening in the back panel and connect to
the inlet on the back of the Icemaker. If you have
installed the optional drain pump (sold separately -
model # RF15I-P), feed the drain line thru this same
large opening. Feed the power cord thru the smaller
opening and install protective grommets on both
openings (Fig. 12).
Fig. 12
Power cord
Drain hose
Vent hose
Water inlet
Rear of Icemaker
shown with
optional drain
pump installed
Fig. 14
Fig. 13
Fig. 11
Ensure
holes
are
aligned
Once you have tested the unit and veried there 10.
are no leaks, align the rear panel male clips to the
preinstalled female clips of the side panels, push at
the outer corners to engage clips. See Fig. 13 for
nal assembly. Do not bundle-up excess hose & cord
behind the panel.
Solid Surface Installation – Required Accessory
(sold separately):
Solid Surface for Icemaker (WRT15I) ■
Locate holes on the solid surface and place onto 1.
the Icemaker so the holes align on the sides.
Check for proper t and alignment. Insert screws
(10-24 X 1-1/8) to anchor solid surface to risers. See
Fig. 14 for nal assembly.
Final check to see that all spacing and gaps are even 2.
and level.