Installation Sheet

2
Place the left side panel on the unit by sliding the 4.
bottom front ange behind the front grill plate
(Fig. 07). Then lift the rear of the panel so the U-nut
holes are visible in the slotted holes of the upper
and lower rear anges of the panel. Install machine
screws (10-24 X 3/8) into U-nuts as shown (Fig. 08
and 09). Do not tighten at this point.
Repeat Step 4 for the other side panel. 5.
Place both top risers on top of unit as shown in 6.
Fig. 10.
Remove (4) screws on back panel of Icemaker as 2.
shown (Fig. 02). (Retain screws for re-use.)
Install 2 Tinnerman U-Nuts on Icemaker Adapter 3.
(Fig. 03) and attach to upper area of Icemaker as
shown (Fig. 04). Repeat for the bottom location
(Fig. 05). Tighten all screws at this point. See
Fig. 06 for nal placement.
Fig. 07
Fig. 10
Bottom front
ange
Screws
Fig. 02
Fig. 03
Fig. 04
Fig. 05
Fig. 08
Fig. 09
U-nut
Icemaker
adapter
Upper
screw
U-nut
near top
U-nut
near oor
Lower
screw
U-nut
Female catch
Screw
Upper rear ange
Female catch
Screw
U-nut
Lower rear ange
Top risers
Side view
Ensure
holes
are
aligned
Ensure
holes
are
aligned
Fig. 06
Icemaker
adapters