Installation Sheet

BNDCNR BEND CORNER BRACKET

INSTALLATION INSTRUCTIONS

Before you begin, read these instructions completely and carefully.

Getting Started

Remove packaging ■

CONTENTS

Eye Goggles

Screwdriver - Phillips #2

7/16” Socket and Ratchet Driver

7/16” Box or Open End Wrench

Description Qty

Bracket Top 1

Bracket Leg 2

Machine Screw #10-24 x 3/4” Phillips 4

Hex Nut 1/4-20 4

Washer 5/16 ID x 3/4 OD 4

Hex Bolt 1/4-20 x 3/4” 4

BND-CNR :

The BND-CNR is composed of three main pieces (one large 1.

bracket top and two bracket legs) that are held together using

four bolts and nuts. The bracket is mounted to the bend units

with four screws (Fig. 01).

Mounting of the BND-CNR bracket requires two CAD-BND 2.

bend units mounted with a CAD-30 cart between them and

any size CAD cart or refrigeration unit with wrapper on the

outer sides. When assembled, this conguration will provide

a solid base to which the BND-CNR bracket can be safely

mounted. The assembly should look similar to the image

below (Fig. 02).

Note: Before beginning installation, remove screws holding the rear of the center outdoor appli-

ance and cart to prevent damage (Fig. 03). Ensure the grill head is secured to the front of the

cart behind the drip pan.

Fig. 02

TOOLS NEEDED

Installation Instructions

Fig. 01

Fig. 03

Over. . .

CAD-BND CAD30 with

outdoor

appliance

CAD-BND

PAGE 1
BND-CNR BEND CORNER BRACKET installation instructions Before you begin, read these instructions completely and carefully. Getting Started ■■ Remove packaging CONTENTS TOOLS NEEDED Description Eye Goggles Qty Bracket Top 1 Screwdriver - Phillips #2 Bracket Leg 2 7/16” Socket and Ratchet Driver Machine Screw #10-24 x 3/4” Phillips 4 7/16” Box or Open End Wrench Hex Nut 1/4-20 4 Washer 5/16 ID x 3/4 OD 4 Hex Bolt 1/4-20 x 3/4” 4 Installation Instructions BND-CNR : 1.
PAGE 2
3. Attach the legs to the backs of the bend units using the provided mounting screws (#10-24 x 1/2” Phillips Machine Screws). Position the legs on the bend units so that the screws are fed through the outer holes on the bracket legs (Fig. 04). 4. Once the legs are securely mounted to the bend units, place the large bracket top on top of the legs (Fig. 05). The bracket top should rest safely on the legs while you secure the parts together. Note: DO NOT place any weight on the shelf until step 5 is complete.