User guide

P5040 DS Hardware Getting Started, Rev. 1.5
42 Freescale Semiconductor
SerDes Options
13 SerDes Options
There are three SerDes module set-up options: SGMII and XAUI riser cards, and PEX loopback cards.
Table 13. SerDes Module Set-ups
SGMII Riser Card
1. Select a configuration scenario; e.g., switch settings.
2. Connect the supplied cables as instructed in Section 12.1,
"Standalone Mode".
3. Insert a SGMII riser card into slots J21, J22 and J24 for
P5040 device or alternatively J20 and J21 for
P3041/P5020 devices.
4. Press SW14 to Power-ON.
XAUI Riser Card
1. Select a configuration scenario; e.g., switch settings.
2. Connect the supplied cables as instructed in Section 12.1,
"Standalone Mode".
3. Insert XAUI riser card into slots J20 and J21.
4. Connect a loopback cable between the two XAUI riser card
connectors (S1/S2?) OR connect a cable to each XAUI
riser card connector and an external destination.
5. Press SW14 to Power-ON.
PEX Loopback
1. Select a configuration scenario; e.g., switch settings.
2. Connect the supplied cables as instructed in Section 12.1,
"Standalone Mode".
3. Insert PEX loopback cards in slots J25 and J26 for P5040
device or alternatively J21, J22, J23, J25 and J26 fro
P3041/P5020 devices.
4. Press SW14 to Power-ON.
J21
J20
SGMII
Riser Cards
J21
J20
XAUI
Riser Cards
J21 J23 J25
J26