User guide

P5040 DS Hardware Getting Started, Rev. 1.5

Freescale Semiconductor 39

HW Getting Started Procedures

Step 8: Connect CW USB TAP.

CAUTION!

Avoid damage, follow the below steps.

1. Align the red stripe of the USB-UTAP connector cable

with Pin 1 of the JTAG/COP 16-pin connector (at J39).

2. Connect the connector cable to J39.

3. Press SW14 to Power-ON.

4. Check for completion of the reset sequence (D3:30).

NOTE!

Freescale’s CW USB TAP enables CW IDE software

to work with P5040 DS (SuperHYDRA)

Step 9: Attach cables per user development needs and planned board use.

1. Ensure (pre-installed) DB9 Cross Gender adapter is

connected to RS-232 J5-Bottom connector.

2. Connect between the DB9 Cross Gender adapter

(J5-Bottom: UART 1/3) and the PC using an RS-232

standard serial cable.

3. Select and connect the appropriate Ethernet RJ45 cable.

a) Connect cross-over cable between J2-Top–GETH1

and P1–GETH2; or,

b) Connect shielded cable at J2-Top–GETH1 and/or

P1–GETH2.

NOTE!

Only one shielded Ethernet RJ45 cable is included in

the P5040 DS (SuperHYDRA)

kit.

4. Connect USB*A-to-MicroUSB*B cable to

J2-Bottom–USB1 (Host).

5. Connect MicroUSB*A-to-USB*A adapter to J1–USB2

(OTG).

6. Continue as per CW Kit Configuration Guide instructions.

Table 11. Getting Started Procedure: Standalone Mode

Getting Started Procedure: Standalone

1 & 2