User guide

P5040 DS Hardware Getting Started, Rev. 1.5

38 Freescale Semiconductor

HW Getting Started Procedures

12.1 Standalone Mode

Table 11. Getting Started Procedure: Standalone Mode

Getting Started Procedure: Standalone

Step 1: Check HW kit contents. Section 4, "Hardware Kit Contents"

Step 2: Check default SW settings. Section 6, "Switch Default Settings"

Step 3: Check default connector settings. Section 7, "Connector Default Settings"

Step 4: Check default jumper settings. Section 8, "Jumper Default Settings"

Step 5: Establish working environment. Section 11, "Working Environment"

Step 6: Assemble and connect ATX12V PS (standalone mode).

NOTE!

Ensure Power-OFF.

1. Assemble ATX12V PS kit: connect country-specific wall

outlet plug to the primary power cable.

2. Connect the ATX12V PS harness to the board.

a) Connect main power connector to J43.

b) Connect +12V2DC connector to J41.

3. Plug the power cable into the wall outlet.

Step 7: Perform initial board Power-ON and check LEDs.

1. Power the board via the external ATX12V PS: LED D29

(HOT_5V) and D18 (HOT_3V3) will glow green.

2. Press SW14 to Power-ON.

3. Check for completion of Power-ON reset sequence as per

LEDs D3:D30; see Section 10, "LED Lights".

4. Press SW14 to Power-OFF.

1 & 3

2a2b

2 & 4