Technical data

54 Network OS Message Reference

53-1002489-01

FABR-1012

Message <timestamp>, [FABR-1012], <sequence-number>,, WARNING, <switch-name>, <function

stream>: no such type, <invalid type>.

Probable Cause Indicates that the fabric is not in the appropriate state for the specified process. This message is

rare and usually indicates a problem with the Network OS.

Recommended

Action

The fabric daemon will take proper action to recover from the error.

If the message persists, run the copy support command and contact your switch service provider.

Severity WARNING

FABR-1013

Message <timestamp>, [FABR-1013], <sequence-number>, FFDC, CRITICAL, <switch-name>, No

Memory: pid=<fabric process id> file=<source file name> line=<line number within

the source file>.

Probable Cause Indicates that there is not enough memory in the switch for the fabric module to allocate. This

message is rare and usually indicates a problem with the Network OS.

Recommended

Action

The system will recover by failing over to the standby CP.

If the message persists, run the copy support command and contact your switch service provider.

Severity CRITICAL

FABR-1014

Message <timestamp>, [FABR-1014], <sequence-number>,, ERROR, <switch-name>, Port <port

number> Disabled: rBridge IDs overlap. Insistent rBridge ID <RBridge ID> could not

be obtained. Principal is trying to assign rBridge ID <RBridge ID>.

Probable Cause Indicates that the switch received an rBridge ID other than the one it requested. The port was

disabled because the requested insistent rBridge ID could not be obtained.

Recommended

Action

Change the rBridge ID of the local node (if applicable) using the vcs rbridge-id command. You can

toggle the disabled port using the fabric isl enable and no fabric isl enable commands after the

rBridge ID change.

Severity ERROR