Technical data

46 Network OS Message Reference
53-1002489-01
EM-1029
8
Recommended
Action
If the message persists, reboot or power cycle the switch.
If the message still persists, replace the WWN card or the switch (for nonbladed switches).
Severity WARNING
EM-1029
Message <timestamp>, [EM-1029], <sequence-number>,, WARNING, <switch-name>, <FRU Id>, a
problem occurred accessing a device on the I2C bus (<error code>). Operational
status (<state of the FRU when the error occurred>) not changed, access is being
retried.
Probable Cause Indicates that the I2C bus had problems and a timeout occurred.
Recommended
Action
This is often a transient error.
Watch for the EM-1048 message, which indicates that the problem has been resolved.
If the error persists, check for loose or dirty connections. Remove all dust and debris prior to
reseating the FRU. Replace the FRU if it continues to fail.
Severity WARNING
EM-1034
Message <timestamp>, [EM-1034], <sequence-number>,, ERROR, <switch-name>, <FRU Id> set to
faulty, rc=<return code>.
Probable Cause Indicates that the specified FRU has been marked as faulty for the specified reason.
Recommended
Action
Try reseating the FRU.
Execute the diag systemverification command to verify that the switch does not have hardware
problems.
If the message persists, replace the FRU.
Severity ERROR
EM-1036
Message <timestamp>, [EM-1036], <sequence-number>,, WARNING, <switch-name>, <FRU Id> is
not accessible.
Probable Cause Indicates that the specified FRU is not present on the switch.
If the FRU is a WWN card, then default WWN and IP addresses are used for the switch.
Recommended
Action
Reseat the FRU card.
If the message persists, reboot or power cycle the switch.