Manualshelf

Technical data

ManualsBrandsDcm ManualsComputer equipmentDCM1212
51525354555657585960
22 Network OS Message Reference
53-1002489-01
AUTH-1031
2
AUTH-1031
Message <timestamp>, [AUTH-1031], <sequence-number>,, ERROR, <system-name>, Failed to
retrieve secret value: port <port number>.
Probable Cause Indicates that the secret value was not set properly for the authenticated entity.
Recommended
Action
Reset the secret value using the no fcsp auth-secret command.
Reinitialize authentication using the shutdown and no shutdown commands or the chassis disable
and chassis enable commands.
Severity ERROR
AUTH-1032
Message <timestamp>, [AUTH-1032], <sequence-number>,, ERROR, <system-name>, Failed to
generate <data type> for <message payload> payload: length <data length>, error
code <error code>, port <port number>.
Probable Cause Indicates that the authentication process failed to generate specific data (that is, challenge, nonce,
or response data) for an authentication payload. This usually relates to internal failure.
A nonce is a single-use, usually random value used in authentication protocols to prevent replay
attacks.
Recommended
Action
Usually this problem is transient. The authentication may fail.
Reinitialize authentication using the shutdown and no shutdown commands or the chassis disable
and chassis enable commands.
If the message persists, execute the copy support command and contact your switch service
provider.
Severity ERROR
AUTH-1041
Message <timestamp>, [AUTH-1041], <sequence-number>,, ERROR, <system-name>, Port <port
number> has been disabled, because an authentication-reject was received with code
'<Reason String>' and explanation '<Explanation String>'.
Probable Cause Indicates that the specified port had been disabled, because it received an authentication-reject
response from the connected switch or device. The error may indicate that an invalid entity
attempted to connect to the switch.
Recommended
Action
Check the connection port for a possible security attack.
Check the shared secrets using the fcsp auth-secret command and reinitialize authentication using
the shutdown and no shutdown commands.