Technical data

176 Network OS Message Reference
53-1002489-01
SULB-1009
35
“firmware commit failed on Active CP.” 0x7d
"The original firmware has been restored successfully on Standby CP." 0x7e
"Unable to restore the original firmware on Standby CP." 0x7f
"Standby CP reboots." 0x80
"Standby CP failed to reboot." 0x81
"Standby CP booted up with new firmware." 0x82
"Standby CP failed to boot up with new firmware." 0x83
“There was an unexpected reboot during firmware download. The command is aborted.” 0x84
"Standby CP was not responding. The command is aborted." 0x85
“firmware commit has started on both CPs. Execute the show firmwaredownloadstatus
command to display the firmware download event log. Execute the show version command
to display the firmware version.”
0x86
“firmware commit has started on the local CP. Execute the show firmwaredownloadstatus
command to display the firmware download event log. Execute the show version command
to display the firmware version.”
0x87
“firmware commit has started on the remote CP. Execute the show firmwaredownloadstatus
command to display the firmware download event log. Execute the show version command
to display the firmware version.”
0x88
“Execute the show firmwaredownloadstatus command to display the firmware download
event log. Execute the show version command to display the firmware version.”
0x89
“firmware download command has completed successfully.” 0x8a
"The original firmware has been restored successfully." 0x8b
"Remote CP is restoring its secondary partition." 0x8c
"Local CP is restoring its secondary partition." 0x8d
"Remote CP is restoring its secondary partition." 0x8e
“firmware download has started.” 0x8f
“firmware commit has started.” 0x90
“firmware download has completed successfully.” 0x91
“firmware commit has completed successfully.” 0x92
“firmware commit has started to restore the secondary partition.” 0x93
“firmware commit failed.” 0x94
"The secondary partition has been restored successfully." 0x95
"Firmware is being downloaded to the blade. This step may take up to 10 minutes." 0xa0
“firmware download timed out.” 0xa1
“Reboot occurred during firmware download. firmware commit will be started to recover the
blade.”
0xa2
“Blade rebooted during firmware commit. The operation will be restarted.” 0xa3
"Firmware has been downloaded successfully. Blade is rebooting with the new firmware." 0xa4
"Blade has rebooted successfully." 0xa5
TABLE 7 Status messages and status codes (Continued)
Status message Status code