Technical data

Network OS Message Reference 175
53-1002489-01
SULB-1009
35
“firmware commit operation failed due to IPC error.” 0x55
"Unable to check the firmware version on Standby CP due to IPC error." 0x56
“Unable to restore the original firmware due to Standby CP timeout.” 0x57
"Standby CP failed to reboot and was not responding." 0x58
"Unable to check the firmware version on Standby CP due to IPC error." 0x59
“Sanity check failed because firmware download is already in progress.” 0x60
“Sanity check failed because firmware download is already in progress.” 0x61
NOT USED 0x62
"System error." 0x63
"Active CP forced failover succeeded. Now this CP becomes Active." 0x64
"Standby CP booted up." 0x65
"Active and Standby CP failed to gain HA synchronization within 10 minutes." 0x66
"Standby rebooted successfully." 0x67
"Standby failed to reboot." 0x68
“firmware commit has started to restore the secondary partition.” 0x69
"Local CP is restoring its secondary partition." 0x6a
“Unable to restore the secondary partition. Execute the show firmwaredownloadstatus
command to display the firmware download event log. Execute the show version command
to display the firmware version.”
0x6b
“firmware download has started on Standby CP. It might take up to 10 minutes.” 0x6c
“firmware download has completed successfully on Standby CP.” 0x6d
"Standby CP reboots." 0x6e
"Standby CP failed to boot up." 0x6f
"Standby CP booted up with new firmware." 0x70
"Standby CP failed to boot up with new firmware." 0x71
“firmware download has completed successfully on Standby CP.” 0x72
“firmware download has started on Standby CP. It might take up to 10 minutes.” 0x73
“firmware download has completed successfully on Standby CP.” 0x74
"Standby CP reboots." 0x75
"Standby CP failed to reboot." 0x76
“firmware commit has started on Standby CP.” 0x77
“firmware commit has completed successfully on Standby CP.” 0x78
"Standby CP booted up with new firmware." 0x79
"Standby CP failed to boot up with new firmware." 0x7a
“firmware commit has started on both Active and Standby CPs.” 0x7b
“firmware commit has completed successfully on both CPs.” 0x7c
TABLE 7 Status messages and status codes (Continued)
Status message Status code