Technical data

Network OS Message Reference 131
53-1002489-01
Chapter
28
RCS System Messages
RCS-1003
Message <timestamp>, [RCS-1003], <sequence-number>,, ERROR, <system-name>, Failed to
allocate memory: (<function name>).
Probable Cause Indicates that the specified Reliable Commit Service (RCS) function failed to allocate memory.
Recommended
Action
This message is usually transitory. Wait for a few minutes and retry the command.
Check the memory usage on the switch using the show process memory command.
Restart or power cycle the switch.
Severity ERROR
RCS-1005
Message <timestamp>, [RCS-1005], <sequence-number>,, INFO, <system-name>, Phase <RCS
phase>, <Application Name> Application returned <Reject reason>, 0x<Reject code>.
Probable Cause Indicates that a receiving switch is rejecting an RCS phase.
Recommended
Action
If the reject is in acquire change authorization (ACA) phase, wait for a few minutes and then retry
the operation from the sender switch.
If the reject is in the stage fabric configuration (SFC) phase, check if the application license exists
for the local rBridge and if the application data is compatible.
Severity INFO
RCS-1006
Message <timestamp>, [RCS-1006], <sequence-number>,, INFO, <system-name>, State <RCS
phase>, Application <Application Name> AD<Administrative RBridge>, RCS CM.
RBridge <RBridge ID that sent the reject> returned 0x<Reject code>. App Response
Code <Application Response Code>.
Probable Cause Indicates that a remote rBridge rejected an RCS phase initiated by an application on the local
switch.
If the reject phase is ACA, the remote rBridge may be busy and could not process the new request.
If the reject phase is SFC, the data sent by the application may not be compatible or the rBridge
does not have the license to support that application.