User manual

12DCA Intertel DCA Intertel
DCA Intertel 13 DCA Intertel
1.2 BATTERIES
1.2.1 Recharging batteries
Appearing in the printer set up print out (see sec. 1.3) is the parameter
HEAD VOLT that gives the battery charge level. To recharge the batteries(4), use the
cable packed with the printer and proceed as follows:
- Connect the battery recharger jack to the cable jack (vedi g. 1.4) and plug the bat-
tery recharger into the electrical mains;
- Connect the cable RJ11 connector to the RJ11 connector located under the printer
(see g. 1.4). For a complete recharge, we recommend that the batteries be left to
charge for two hours;
(4) NOTE
During the recharge operation it’s not possible turning the printer off.
WARNING
Incorrect battery recharge voltage (different from that given in tab.
1.2) could seriously damage the printer.
Tables 1.1 and 1.2 provide specications for the battery recharger
Pin Signal IN/OUT Description
1 +VRIC Power Battery recharge
2 GND Power Ground signal
MAX recharge current 0.6 A
MAX recharge voltage 12V - 36V