User manual
12DCA Intertel DCA Intertel
DCA Intertel 13 DCA Intertel
1.1.2 Turning the printer On and Off
How to turn the printer On
• by briey pressing the multi-function key
• by sending a characters set on the serial line—it is better to send
characters that are not read as printer controls (ex. 0x0E)
• with the battery recharger connected
How to turn the printer Off (1)
• by briey pressing the multi-function key
• by sending the character ESC 0 over the serial line
• following a given period of inactivity as specied in setup (see sec. 1.3)
Turning the printer On and Off using software commands
If the printer is off, sending a characters set on the serial line will turn it on
(2)(3). Follow the instructions shown in the diagram below:
(1) NOTE
If the printer is connected to the battery recharger and it recharging the bat-
teries it’s not possible to turn off the printer. It must wait that the operation in
terminated.
(2) NOTE
It’s not possible to turn on
the printer sending one or
more characters through the
infrared device.
(3) NOTE
The printer start up
will not occur before
200-250 msec. This
delay is caused by
internal component.