Technical information

12DCA Intertel DCA Intertel
DCA Intertel 13 DCA Intertel
2.5 Printer Set up
The MP 2000 can operate with different hardware/software. It can be congurated by
using the SW1/SW2 DIP-switch set, as shown in Fig. 3 The function of the DIP-swit-
ches is shown in Table 3.
TABLE 3 - DIP SWITCHES
Dip Switch Function
SW1-1 Baud rate (see table 4)
SW1-2 Baud rate (see table 4)
SW1-3 for serial interface:
ON = XON/XOFF mode
OFF= DTR/DSR mode
SW1-4 National character set (table 5)
SW1-5 National character set (table 5)
SW1-6 National character set (table 5)
SW1-7 CRLF mode: ON= enabled OFF= disabled
SW1-8 STAND-BY mode: ON= enabled OFF= disabled
NOTE: Factory standard setting: 4,5,6, ON
TABLE 4 - BAUD RATE SELECTION
Baud rate SW1-1 SW1-2
1200 ON ON
2400 OFF ON
4800 ON OFF
9600 OFF OFF
TABLE 5 - NATIONAL CHARACTER SET SELECTION BY DIP SWITCH
National character set SW1-6 SW1-5 SW1-4
USA ON ON ON
FRANCE ON ON OFF
GERMANY ON OFF ON
GREAT BRITAIN ON OFF OFF
DENMARK OFF ON ON
SWEDEN OFF ON OFF
ITALY OFF OFF ON
SPAIN OFF OFF OFF