Technical information

10DCA Intertel DCA Intertel
DCA Intertel 11 DCA Intertel
QUICK JUMP COMMAND
ESC #j+d+n
The printer makes a forward or backward feed of the paper of “n” lines.
d= 0 (binary or ASCII): forward feed
d= 1 (binary or ASCII): backward feed
n= number of lines (the dimension is set up by the proper command) to feed.
The paper feeding is limited according to the form dimensions. The dimension is set up
by the proper command (default 11 inches): it is not possible to go backward over the
top of the form or to go forward over the edge of the form.
Before the feeding of the paper, the printer will print out the contents of the line buf-
fer.
READING OF TOF STATUS
It can be read on bit “b1” of the status byte: 1 = TOF sensor covered.
The TOF sensor is detected by regular periods.
During the form setting, the sampling is quicker than normal, in order to have more
precise precision. In all the other operating conditions, the TOF signal is tested every
100 msec.