Installation guide

SC 32 / SC 64
Section 4
Technical Specifications
15
®
Section 4 - Technical Specifications
FRONT PANEL INDICATORS
Per channel: 48V (yellow), CLIP (red), SIGNAL (green)
Per 8 channel bank: IN (green), OUT (amber), D-IN (blue), D-OUT (yellow), SYNC (green)
Other: 16x2 LCD display, PAGE button (green), SELECT button (green), CLIP (red),
LINK/ACT (green), RS-232 (green), POWER (green)
ANALOG INPUTS
Connectors: Phoenix/Combicon, 3.5mm pitch
Channels: Eight per card
Line/Mic Inputs: Nominal gain 0 dB
Electronically switchable to +6, +12, +18, +24, +30, +36, +42, +48 dB
Type: Electronically balanced, RF Filtered
Input Impedance: 3.5 kΩ
Maximum Input Level: +20 dBu
Noise Floor: -92 dBu “A” weighted
-90 dBu unweighted, 20 Hz – 20 kHz
Dynamic Range: 113 dB “A” weighted, 20 Hz – 20 kHz
110 dB unweighted, 20 Hz – 20 kHz
CMRR: > 40 dB typical, >50 dB at 1 kHz
EIN: < -119 dBu unweighted, 20 Hz – 20 kHz, 150 Ω source impedance
Phantom Power: +48 VDC selectable per input
A/D Latency: 12/Fs
ANALOG OUTPUTS
Connectors: Phoenix/Combicon, 3.5mm pitch
Channels: Eight per card
Type: Electronically balanced, RF Filtered
Impedance: 44Ω
Maximum Output Level: +20 dBu
Noise Floor: -92 dBu “A” weighted
-89 dBu unweighted, 20 Hz – 20 kHz
Dynamic Range: 112 dB “A” weighted
109 dB unweighted, 20 Hz – 20 kHz
D/A Latency: 10.4/Fs
SYSTEM PERFORMANCE
Dynamic Range: 110 dB “A”weighted
107 dB unweighted, 20 Hz to 20 kHz
Frequency Response: 20 Hz – 20 kHz, +0/-0.5 dB
THD+N: 0.0045% 0 dBu input, 1 kHz, 0 dB input gain
0.0065% 0 dBu input, 20 Hz – 20 kHz, 0 dB input gain
Inter-channel crosstalk: > 90 dB typically, 20 Hz - 20 kHz
Internal Processing: 32 bit floating point
Internal Sample Rate: 48 kHz
Latency: 1.82 msec analog input to analog output
2.25 msec analog input to analog output with a mono mid-mixer
CONTROL INPUTS
Connector: Phoenix/Combicon, 3.5mm pitch
Number: 8
Control Voltage Input: 0 to 4.5 VDC
Control Line Impedance: 4.7 kΩ to +5 VDC