User manual

®
Application Guide
Section 6
IEM
33
®
IEM User Manual
Hardware
1. Connect the stereo mix output 1 and 2 from the mixer to Inputs 1 and 2 of the selected
crossover, sending the High/Mid or Fullrange outputs to the IEM, and the low outputs to
the amplifier.
2. Connect Outputs 1 and 2 from the IEM to inputs 1 and 2 of the Wireless Transmitter.
Software
1. Once signal is passing through the unit, adjust levels on the front panel of the IEM.
2. Make adjustments to each individual effect by pressing each respective effect button, and
then proceed to make parameters adjustments accordingly.
6.2 Mixer to IEM with Bandpass Sub
Out-
Stereo Mix
Output - 1
In
IEM
Input -Ch 1
Out-
Stereo Mix
Output - 2
In
IEM
Input - Ch 2
Out-
IEM
Ch - Ch1
Out-
IEM
Ch - 2
In
In-Ear Trans.
Input -Ch 1
In
In-Ear Trans.
Input -Ch 2
X-Over
Power Amp
Subwoofer