User manual

Detailed Parameters
®
24
Section 4
IEM
IEM User Manual
Section 4
EQ On/Off
This control turns all 5 bands on and off.
Type Const Q / Adapt Q
This controls effects all 5 bands.
Const Q operates similar to an analog graphic EQ where the Q is constant regardless of cut or
boost. Whereas, Adaptive Q, operates similar to the EQ that is found on a mixing console where
the width of the band is constant regardless of the cut or boost.
The following figure shows the difference between constant and adaptive Q parametric filters.
Band 1 FC 20.0 Hz to 20.0 kHz
This controls the corner frequency for the low frequency shelving EQ band.
Slope 3 to 12 dB / Octave
Sets the slope of the shelf.
Level -12 to + 12 dB
Amount of boost or cut. Adjustable in 1/2 dB steps.
Band 2, 3, 4 FC 20.0 Hz to 20.0 kHz
This controls the center point for the parametric EQ.
Q 0.25 to 16.0
Sets the width of the boost / cut.
Level -12 to + 12 dB
Amount of boost or cut. Adjustable in 1/2 dB steps.
Band 5 FC 20.0 Hz to 20.0 kHz
This controls the corner frequency for the high frequency shelving EQ band.