User manual

®
Software Operations
Section 3
IEM
15
IEM User Manual
4. Now the display will prompt you to either “Replace Old” or “Store New.” By selecting
“Replace Old,” you will be replacing an existing program with your edited program in its place.
If you replace, you will be given the option of which program you will be replacing.
By selecting “Store New,” you will store your edited program within the user program table.
You will be given the option of placing your edited program anywhere within the user program
table.
Bypass
To bypass the IEM, press and hold the BYPASS button for at least two seconds. All digital
dynamics modules and reverb are rendered inactive.
Analog Meters
The IEM’s analog input meters show the signal after the input controls. These analog meters are
referenced in dBu. The meter will accurately represent the input level only when the input con-
trols are set to zero.
TSE™ Level Meters
These meters show that the program material has entered into Tape Saturation Emulation.
Digital Meters
The middle portion of the meter represents the peak level of the signal. The sides of the meter
represent the average peak level. Digital clipping is represented by a large “C” at the top of
the meter. PeakStopPlus™ limiting is represeted by a large “P” at the top of the meter.
Analog Meters
TSE“
3.4 Meters
3.3 The Bypass Function