User manual

Navigation
®
8
Section 2
IEM
IEM User Manual
Navigate through
the bands by
depressing the
"Compressor"
button
successively until
arriving at the
desired band
All
Bands
Band
1
Band
2
Band
3
Band
4
Navigate through the Pages by depressing "Next Page" or "Prev Page"
successively until arriving at the desired Page
Compr On/Loc/Off
OverEasy®
Auto Loc/On/Off
Threshold
Ratio
Gain
Attack
Hold
Release
Band 1 On/Off
OverEasy®
Auto
Threshold
Ratio
Gain
Attack
Hold
Release
Band 2 On/Off
OverEasy®
Auto
Threshold
Ratio
Gain
Attack
Hold
Release
Band 3 On/Off
OverEasy®
Auto
Threshold
Ratio
Gain
Attack
Hold
Release
Band 4 On/Off
OverEasy®
Auto
Threshold
Ratio
Gain
Attack
Hold
Release
Page 1 Page 2 Page 3
Control of each of the bands within the IEM’s multiband dynamic modules is made possible
in two different ways. You may either use the “All page” or individual band adjustments. The
“All page” is signified by a large “All” seen where the program number would normally be.
Adjusting settings in this page will adjust the settings in all four bands as a group. To control
individual bands within the “All page” press the EDIT ALL/BAND button to cycle through each
band. Pressing the dynamic module’s button again will cycle you through the separate bands
and the dynamic controls of those bands e.g., compressor or limiter.
Refer to the Navigation illustrations for a complete view of the parameters available in each
Multiband Dynamic Module.
2.1 Navigating the Multiband Compressor section
NAVIGATION