User manual

Application Guide
®
®
®
®
®
®
32
Section 5
DriveRack
®
PA
Hardware
1. Connect the outputs from the mixer to the inputs of the DriveRack
®
.
2. Connect the outputs of the DriveRack
®
PA and run to the selected speaker amplifier.
3. Make sure that the mixer and power amps are turned off prior to powering up the
DriveRack
®
PA.
Software
1. From Program mode, select factory program #F14 (MP212 2X4) as a template, or use the
Wizard to setup the specific program.
2. Once the program has been chosen, press the DATA wheel to load the program.
5.3 2X4 Crossover
DriveRack
®
PA User Manual
Left
Right
Left High
Right High
Left Low
Right Low
Left High
Right
Right High
MP412 MP412
MP4718SP
Powered
MP4718S
Non-Powered