User Manual

3
U. K. M AINS PLUG WARNING
A m olded mains plug that has been cut off from the cord is unsafe.
Discard the mains plug at a suitable disposal facility. NEVER UNDER
ANY CIRCUMSTANCES SHOULD YOU INSERT A DAMAGED OR CUT
M AINS PLUG INTO A 13 AMP POWER SOCKET. Do not use the
mains plug without the fuse cover in place. Replacement fuse covers
can be obtained from your local retailer. Replacem ent fuses are 13
amps and M UST be ASTA approved
to BS1362.
LITHIUM BATTERY
W ARN ING
CAUTION!
This product may contain a lithium battery.There is dan-
ger of explosion if the battery is incorrectly replaced.
Replace only with an Eveready CR 2032 or equivalent.
Make sure the battery is installed with the correct polari-
ty. D iscard used batteries according to manufacturer’s
instructions.
ADVARSEL!
Lithiumbatteri - Eksplosjonsfare.Ved utskifting benyttes
kun batteri som anbefalt av apparatfabrikanten. Brukt bat-
teri returneres apparatleverandøren.
ADVARSEL!
Lithiumbatteri - Eksplosionsfare ved fejlagtig håndtering.
Udskiftning må kun ske med batteri av samme fabrikat og
type. Levér det brugte batteri tilbage til leverandøren.
VAROIT US!
Paristo voi räjähtää, jos se on virheellisesti asennettu.
Vaihda paristo ainoastaan laitevalmistajan suosittelemaan
tyyppin. H ävitä käytetty paristo valmistajan ohjeiden
mukaisesti.
VARNING!
Explosionsfara vid felaktigt batteribyte. Använd samma bat-
terityp eller en ekvivalent typ som rekommenderas av
apparattillverkaren. Kassera använt batteri enligt fabrikan-
tens instruktion.
IMPORTANT SAFETY IN STRUCTIONS
ELECTROMAGNETIC
COMPATIBILITY
This unit conforms to the Product
Specifications noted on the Declaration
of Conformity. O peration is subject to
the following two conditions:
• this device may not cause harmful
interference, and
• this device must accept any interfer-
ence received, including interference
that may cause undesired operation.
O peration of this unit within significant
electromagnetic fields should be avoided.
• use only shielded interconnecting
cables.
DECLARAT ION OF
CON FORMITY
Manufacturer’s N ame: dbx Professional Products
Manufacturer’s Address: 8760 S. Sandy Parkway
Sandy, Utah 84070, USA
declares that the product:
Product name: dbx 131, 215 and 231
N ote: Product name may be suffixed
by the EU.
Product option: N one
conforms to the following Product Specifications:
Safety: IEC 60065 (1998)
EMC: EN 55013 (1990)
EN 55020 (1991)
Supplementary Information:
The product herewith complies with the requirements
of the Low Voltage D irective 72/23/EEC and the EMC
D irective 89/336/EEC as amended by D irective
93/68/EEC .
Vice-President of Engineering
8760 S. Sandy Parkway
Sandy, Utah 84070, USA
D ate:April 19,2002
European Contact: Your local dbx Sales and
Service O ffice or
Harman Music Group
8760 South Sandy Parkway
Sandy, Utah 84070 USA
Ph:[phone]
Fax: [phone]