User manual

Http://www.hybertone.com HT-822P VoIP FXS+PSTN Gateway
42
1） Bridge Mode
In the Bridge Mode, the ATA allows a PC connected to it to pass through to the network.
No other PC Configuration settings are set; the Advanced Settings, Gateway, Primary and
Secondary DNS field settings are not required and will be ignored.
2） Specify an IP Address Manually
Click Static IP, and enter IP Address and Subnet Mask.
3） Enable DHCP Service
To Enable DHCP Service, you have to know the starting address, which is used to start
the service; and the ending address, which is used to end this service. The HT-822P’s
DHCP server must running by PC Port using Static IP mode.
4） Advance…
Click Advance and you will see the following two items: Hardware address and Broadcast
address.