User manual

Http://www.hybertone.com HT-822P VoIP FXS+PSTN Gateway

In a typical geographically determined network, users input telephone numbers manually.

If you obtain a static IP address from your ISP, you can assign it to the ATA LAN port by

clicking the Static IP Address Manually, and then entering the IP Address, Subnet Mask,

and Default Route.

3） PPPoE

PPPoE, point-to-point protocol over Ethernet, is a network protocol for encapsulating PPP

frames in Ethernet frames. It is used mainly with cable modem and DSL (Digital

Subscriber Line) services. Click PPPOE, and you can set user name and user password.

4）. Advance…

Click Advance and you will see the following two items: Hardware address and Broadcast

address.

Hardware Address is an address used to enter the MAC address in XX: XX: XX: XX: XX:

XX format.

Broadcast Address is an address used to communicate with the other computers

connected to the PC side of the ATA.

4.8.2 PC port configurations

PC port is configured to make a connection of the network and ATA. There two modes to

configure a PC port: Bridge Mode and Static IP.