User manual

Http://www.hybertone.com HT-822P VoIP FXS+PSTN Gateway
22
F. Enable Auth
If you click the “Enable Authentication” field, you will have to configure the Auth ID and
Password. A pair of authentication ID and password is usually needed to use the ATA.
4.4.1.2 Configuration by Line
In this mode, you will have more advance control over the two FXS ports. Firstly, phone 1
and phone 2 will refer to different service providers for related service. Secondly, you can
bind the phone numbers or the FXS ports with each phone. That is to say, one phone
terminal can be bound with one phone numbers. You will have to set the bellow items into
different values. The configuration page is shown as below. The option setting please
follows section “Single Configuration” for detailed information.
4.4.1.3 Configuration by Group
In this mode, each FXS port can be bound with two H.323 service providers; That is to say,
one phone terminal can be bound with two phone numbers. The configuration page is
shown as below. The option setting please follows section “Single Config” for detailed
information.