User manual

Http://www.hybertone.com HT-822P VoIP FXS+PSTN Gateway
15
4.2 Status
As shown in the figure above, there are four main fields to be configured on the Status
page.
4.2.1 Phone Information
A. Serial Number
Each ATA has a unique serial number assigned by the factory such as
HT822POLDTEST09. This number is important for centralized configuration, technical
support, and warranty repair. This number is printed in the back of the ATA and is
associated with your software license. This field is read-only.
B. Firmware Version
Firmware version refers to the software version of the ATA such as A38HS-3.11-1,
which is used to identify the software version.
C. Hardware Revision
These fields show terminal’s hardware type.
D. Phone Status
This field shows the status of Line’s connection status. If the connection is successful,
this field displays LOGIN. Otherwise show LOGOUT.
4.2.2 Network Information
A. LAN Port Configuration
This field shows the current IP address used by LAN port such as 192.168.100.119.
The ATA LAN port can be configured to obtain its IP address by DHCP or the IP
address can be set statically, used mainly while using the ATA with a DSL line.
B. PC Port Configuration
This field shows the current IP address used by PC port. In the Bridge Mode, the ATA
allows a PC connected to it to pass through to the network. No other PC Configuration
settings are set; the Advanced, Gateway, Primary and Secondary DNS field settings
are not required and can be ignored.
C. PPPoE
This field shows the status of your broad band connection with Dial-up networking in
the ATA has not been enabled. The ATA is designed to be used over the Internet with a
broadband connection.
D. Default Route
Default Route is the IP address of a router that is used when a device sends a packet
to another subnet or when a device sends a packet to an unknown destination.
E. DNS Server
Each zone is served by at least one Domain Name Server, which contains the
complete data for the zone. (To make the DNS tolerant of server and network failures,