User manual

得伯乐科技有限公司
DBL Technology Limited GoIP User Manual
Web: www.dbltek.com
Tel: [phone]
The setting parameters are defined as follows:
Each prompt tone involves the following parameters. If a parameter is not defined, the value of
the parameter shall be 0.
<nc, rpt, c1on, c1off, c2on, c2off, c3on, c3off, f1, f2, f3, f4, p1, p2, p3, p4>
nc: the number of tones (1-4)
rpt: the number of repeats (0 to infinity)
c1on: the duration when the frequency 1 is on (ms)
c1off: the duration when the frequency 1 is off (ms)
c2on: the duration when the frequency 2 is on (ms)
c2off: the duration when the frequency 2 is off (ms)
c3on: the duration when the frequency 3 is on (ms)
C3off: the duration when the frequency 3 is off (ms)
f1: the frequency of tone #1, 300 to 3000Hz
f2: the frequency of tone #2, 300 to 3000Hz
f3: the frequency of tone #3, 300 to 3000Hz
f4: the frequency of tone #4, 300 to 3000Hz
p1: the increment of tone #1, 0 to 31(0=3dB, -1dB increments)
p2: the increment of tone #2, 0 to 31(0=3dB, -1dB increments)
p3: the increment of tone #3, 0 to 31(0=3dB, -1dB increments)
p4: the increment of tone #4, 0 to 31(0=3dB, -1dB increments)
Example:
To add a prompt tone where f1 is 450Hz, c1on is 750ms, and c1off is 1000ms, enter the
following values in the corresponding boxes:
1,0,750,1000,0,0,0,0,450,0,0,0,20,0,0,0