User manual

得伯乐科技有限公司
DBL Technology Limited GoIP User Manual
Web: www.dbltek.com
Tel: [phone]
3.3.3 DTMF Minimum Detection Interval
This parameter is used to set the minimum interval of two DTMF signals. Packets may be lost
during the data transmission over the GSM. As a result, a DTMF may be incorrectly identified as two
or multiple identical DTMFs when detected by the GoIP. The problem of repeated code can be solved
effectively through the modification of the parameter.
This parameter value ranges from 60ms to 120ms and the default value is 80ms. When the value
of this parameter is increased properly, the repeated DTMF can be avoided efficiently. However, the
packet loss may also be caused.
3.3.4 Automatic Setting
If the service provider provides the automatic setting, you can select “Enable” to start the
automatic setting feature and enter the address of the server. If the service provider does not provide
the automatic setting, you need to select “Disable” to speed up the startup time of the GoIP.
It is a special server, which needs the support of the specific system.
3.3.5 Setting of the Remote Control
Press *20# on the terminal to initiate the request to realize the remote management of equipment.
The remote control server is provided by the service provider. The default port is 1920 and the
terminal is identified by the SN. The remote control password is identical with that of the server and is
set as default.