User's Manual
www.dbtechnologies.cominfo@dbtechnologiesͲaeb.com
SYA12 Rev1.0cod.420120309Q
Tech specs selection
Acoustics
Speaker Type: 2-way active speaker
HF compression driver: 1 " Exit
HF voice coil: 1.35”
LF: 12”
LF Voice Coil: 2.5”
Horizontal dispersion: 90°
Vertical dispersion: 70°
Amplifier
Amp Technology: Custom made
Amp Class: Class-D + A/B– Active Fan cooling
RMS Power: 400 W
Operating voltage (
factory set
):
220-240V~ (50-60Hz) or
110-120V~ (50-60 Hz)
Processor and user interface
Controller: 24 bit
AD/DA Conversion: 48 kHz
Limiter: Peak, RMS
Controls: Line/mic, Channel Volume, Link/Mix, Presets
Input / Output
Mains connections: VDE
Signal Inputs: 3 channels (Combo, XLR+trs, Bluetooth )
Signal Out: (Balanced) 1x XLR OUT (LINK)
Mechanics
Housing: Polypropylene
Handles: 3 (2 on sides. 1 on the top)
Width: 365 mm (14.37 in)
Height: 622 mm (24.51 in)
Depth: 342 mm (13.46 in)
Weight: 15.4 kg (33.9 lbs)
CHECK www.dbtechnologies.com FOR THE FULL TECH SPECS
EMI CLASSIFICATION
According to the standards EN 55032 and EN 55035 this equipment is designed and suitable to operate in class B electromagnetic
environments
.
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth® SIG, Inc. and any use
of such marks by AEB Industriale SRL is under license. Other Trademarks and trade names are those of their
respective owner.
WARNING: Make su
re that the loudspeaker is securely installed in a stable position to avoid any injuries or damages to persons or properties.
For safety reasons do not place one loudspeaker on top of another without proper fastening systems. Before hanging the loudspeaker check
all the components for damages, deformations, missing or damaged parts that may compromise safety during installation. If you use the
loudspeakers outdoor avoid spots exposed to bad weather conditions.
Contact dB Technologies for accessories to be used with speakers. dBTechnologies will not accept any responsibility for damages caused by
inappropriate accessories or additional devices.
Features, specification and appearance of products are subject to change without notice.
dBTechnologies reserves the right to make changes or improvements in design or manufacturing without assuming any obligation to change
or improve products previously manufactured.
Scan with your QR Reader
App to download the
complete User Manual
Download the complete user manual from the site:
www.dbtechnologies.com/EN/Downloads.aspx
www.dbtechnologies.cominfo@dbtechnologiesͲaeb.com
SYA12 Rev1.0cod.420120309Q
Quick start user manual
Section 1
CHECK www.dbtechnologies.com FOR THE LAST REVISION OF THIS DOCUMENT, FULL TECH SPECS, AND COMPLETE USER MANUAL
The warnings in this manual must be observed together with the "USER MANUAL - Section 2".
Le avvertenze nel presente manuale devono essere osservate congiuntamente al “MANUALE D’USO - Sezione2”.
Die Warnungen in diesem Handbuch müssen in Verbindung mit der "BEDIENUNGSANLEITUNG - Abschnitt 2" beobachtet
werden”.
Les avertissements specifiés dans ce manuel doivent être respectés ainsi que les "CARACTERISTIQUES TECHNIQUES -
Section 2"
Las advertencias del presente manual se deben tener en cuenta conjuntamente con las del “MANUAL DEL USUARIO” -
Sección 2”.
A.E.B. Industriale Srl Via Brodolini, 8 Località Crespellano 40053 VALSAMOGGIA BOLOGNA (ITALIA)
Tel +39 051 969870 Fax +39 051 969725 www.dbtechnologies.com info@dbtechnologies-aeb.com