User Manual

56
INGENIA IG4T Cod. 420120235 REV. 1.2
The system types available when using the IG4T are 2:
In the “Stacked” conguration an IG4T speaker rests on a stand, or one or 2 speakers rest on a subwoofer (see
chapter INSTALLATION EXAMPLES); in the “Flown” conguration, instead, one or two IG4T speakers are hanging.
After accessing the SYSTEM TYPE menu, then:
This menu allows to save and then recall the system usage congurations.
Even though at switch-off the IG4T retains all the information about the
latest settings, it may be useful to have at one’s disposal, for different
contexts, a previously saved batch of appropriate settings, and to be able
to quickly reload them. To this purpose, IG4T allows to save and rename 5
batches of settings, using the “SAVE” function, and to recall them using the
“RECALL” function. Should you later have to edit the settings stored in one
of the memory slots, you can later overwrite the previously saved slots.
• Stacked
• Flown
• Select and conrm the desired mode, choosing between “Stacked” and “Flown”; select and conrm NEXT
to access the next screen (select and conrm BACK to return to the previous one). Now, if the system has
previously detected the presence of 2 speakers, it will switch to the SYSTEM COVERAGE menu, and if the
presence of a woofer has been selected in the previous SYSTEM STRUCTURE sub-menu, it will then switch to
the SUBWOOFER MATCHING menu; should that not be the case (Speakers 1, Subwoofer 0) the next screen will
be the initial one, and the procedure will end.
SYSTEM TYPE
ATTENTION!
• Never install the speaker directly resting on the ground, but always use
the optional GSA-IG.
• When “Stacked” on a tripode stand, the INGENIA IG4T cannot be
mounted in the conguration with 2 speakers stacked, but only in a
single speaker conguration, for safety reasons.
SAVE/LOAD SYSTEM MENU
Save/Load System Menu
English