User Manual
45
INGENIA IG4T Cod. 420120235 REV. 1.2
ATTENTION!
Never use the speaker for a prolonged
time while the limiter LED is on or
blinking, indicating the equipment is
running under excessive stress conditions
with distorted sound.
INPUT AND CONTROL SECTION
1. “PEAK” LED
Red LED that lights up briey when connecting power or in
case of audio limiter operation.
2. OLED DISPLAY
The display automatically orientates according to the
accelerometer control, detecting whether the speaker has been installed
ATTENTION!
ATTENTION!
The USB SERVICE DATA connection must only be used to update the
product rmware; never connect any USB device to the equipment, to
avoid possible damages or malfunctions.
Only use cables equipped with high-quality Neutrik® original
connectors. Using different or poor-quality connectors might affect
the speaker operation.
3. PUSH ROTARY ENCODER
The push rotary encoder allows both a rotary selection (selection of menus and values), and a push selection
(selection conrmation) to navigate the menus.
4. USB SERVICE DATA
The type B mini-USB B port allows to update the product rmware. For further information, please refer to
the Web site http://www.dbtechnologies.com in the “DOWNLOADS” section and to chapter UPDATING THE
FIRMWARE)
5. “LINK” OUTPUT
Balanced “XLR” output, allowing to send the input audio signal to another amplied speaker.
6. “INPUT” COMBO INPUT
Combined XLR-TR-TRS audio signal input. It allows to use a balanced XLR connector, or a ¼” TS or TRS jack input.
straight vertically or ipped. The user can congure a contrast adjustment and automatic power-off function (see
chapter CONTROL PANEL AND SETTING MENUS).
7. “INPUT SENSITIVITY” SELECTOR
A selector allowing to set whether the incoming signal comes from a mixer/a line (“LINE”) or from a microphone
(“MIC”).
English