User Manual

65
INGENIA IG2T Cod. 420120238 REV. 1.1
FLOWN INSTALLATION
Flown conguration provides for the hanging of 1 or 2 IG2T speakers, where the
optional accessory DRK-IG allows the use of a shackle, and the combination of
DRK-IG with the optional truss adapter TA-IG allows xing on a specic device,
such as a rig. When the speakers are in a own conguration, it is very advisable to
use both power supply and signal linking, to reduce the complexity of connections,
as shown in the “FIRST SWITCH-ON” section.
ATTENTION!
• When used outdoors, anchor the speaker to prevent any
oscillations due to atmospheric agents and wind.
• Never use the handles to suspend the speaker!
FLOOR INSTALLATION
It is possible a oor installation of 1 or 2 INGENIA IG2T using the accessory GSA-IG.
A mechanical xing with screws or screw anchors suited to the type of ooring is
required.
INSTALLATION WITH WALL BRACKETS
INGENIA IG2T can be installed on a wall using the optional brackets WB-IG2. Select
the position so as to obtain optimal coverage. In the case of properly installed dual
vertical speaker (it is mandatory in this case to use LP-IG), consider the possibility
of using digital steering technology (see paragraph). For details, refer to the
instructions of WB-2
English