User Manual
Table Of Contents
- 1. INFORMAZIONI GENERALI
- 2. PRIMA ACCENSIONE
- 3. ESEMPI DI UTILIZZO ED INSTALLAZIONE
- 4. AGGIORNAMENTO DEL FIRMWARE
- 5. RISOLUZIONE DEI PROBLEMI
- 6. SPECIFICHE TECNICHE DVA K5
- 1. GENERAL INFORMATION
- 2. FIRST SWITCH-ON
- 3. INSTALLATION EXAMPLES
- 4. FIRMWARE UPDATES
- 5. TROUBLESHOOTING
- 6. TECHNICAL SPECIFICATIONS DVA K5
36
DVA K5 Code 420120232 REV.1.0
English
• Only use cables equipped with Neutrik® connectors
• Replace any damaged cables, to avoid malfunctions and
poor sound quality.
• Connect the cable from MIXER/LINE to the BALANCED AUDIO (1) input of the rst
line array module. For this purpose, use a cable equipped with an XLR connector (not
included in the supply). For further information about the cables that are available
please refer to the picture at p. 37.
• Extend the signal between the rst and the second module. To this purpose connect
the OUTPUT/LINK (2) output to the BALANCED AUDIO (1) input of the second module.
• Repeat the operation between the second and the third module, and so on, until all
line-array modules are connected.
INPUT CONNECTION AND EXTENSION
MIXER/LINE
SECOND DVA K5 MODULEFIRST DVA K5 MODULE
ATTENTION!
LINK